DESIGN AND IMPLEMENTATION OF AUTOMATIC SLUDGE PUMPING SYSTEM USING SUBMERSIBLE PUMP AND STRAINER WITH FLOAT LEVEL SWITCH OIL IN CARRIGE TIPPLER TRANSFER POND IN SEMILAR PALM OIL FACTORY
DOI:
10.54443/ijset.v4i8.1047Published:
2025-07-31Downloads
Abstract
In the wastewater management process at Semilar Palm Oil Mill, sludge accumulation in the carriage tippler transfer pit often obstructs flow to subsequent treatment units. To address this issue, an automatic sludge pumping system was designed and implemented using a submersible pump, strainer, and float level switch. This system is engineered to operate automatically based on sludge level, eliminating the need for manual operation by workers. The design involved selecting a submersible pump suitable for sludge characteristics and required flow rate, installing a strainer to prevent large solid particles from entering and clogging the pump, and using a float level switch with dual-point control (high and low levels) to automate the pump's start-stop cycle. The system was installed directly in the transfer pit and calibrated for stable performance in a muddy and corrosive environment. Implementation results show that the system significantly reduced the pit drainage time and minimized downtime due to clogging. During the trial period, the system operated reliably, responded effectively to sludge level changes, and improved operational efficiency by reducing manual intervention. This system provides a reliable and practical solution for sludge handling in palm oil mills while supporting more efficient and environmentally friendly waste management practices.
Keywords:
sludge submersible pump float level switch strainer automation carriage tippler palm oil millReferences
Abdullah, M., & Santoso, D. (2023). Fundamentals of fluid mechanics and its applications to industrial pump systems.
Ardiansyah. (2020). Energy efficiency in an automatic pumping system using an oil float level switch. Journal of Industrial Engineering, 15(2), 45–58.
Çengel, Y.A., & Boles, M.A. (2020). Thermodynamics: An Engineering Approach (9th ed.). McGraw-Hill Education
Cheah, WY, Yusoff, MHM, Show, PL, & Ling, TC (2023). Circular economy in the palm oil industry: Practices, challenges and future perspectives. Journal of Material Cycles and Waste Management, 25(2), 437–450. https://doi.org/10.1007/s10163-023-01745-9
Fox, R.W., McDonald, A.T., & Pritchard, P.J. (2021). Introduction to fluid mechanics (10th ed.). Wiley.
Gandhi, M. K., & Singh, S. (2022). Pump handbook and calculations. Springer.
Gumilar, G., Santoso, A., & Sari, DN (2022). Potential of palm oil mill effluent (POME) as a source of renewable energy in Indonesia. Journal of Engineering and Technological Sciences, 54(3), 365–378. https://doi.org/10.5614/j.eng.technol.sci.2022.54.3.6
Hibbeler, R. C. (2020). Engineering mechanics: Statics & dynamics (15th ed.). Pearson.
Hidayat, M. (2017). Analysis of the reliability of the pumping system in a palm oil mill. Journal of Mechanical Engineering, 10(1), 22–34.
I Nyoman Gede Baliarta. (2020). The effect of automatic level sensors on energy consumption efficiency in pumping systems. Journal of Technology and Engineering, 8(3), 66–78.
Khairuddin, MN, Ismail, M., Hassan, MA, & Shirai, Y. (2020). Utilization of palm oil mill effluent sludge as organic fertilizer: Characterization and field application. AgrivitaJournal of Agricultural Science, 42(3), 401–410. https://doi.org/10.17503/agrivita.v42i3.2380
McClements, D.J. (2020). Development and Delivery of Functional Foods: Using Food Science and Technology to Improve Nutrition and Health. CRC Press.
Metcalf & Eddy, Inc., Tchobanoglous, G., Stensel, H.D., Tsuchihashi, R., & Burton, F.L. (2019). Wastewater Engineering: Treatment and Resource Recovery (5th ed.). McGraw-Hill Education
Putri, A., Santoso, R., & Widodo, B. (2021). Implementation of level sensors in palm oil pumping to prevent material loss. Journal of Food Technology, 12(4), 101–113.
Rahman, F., Susanto, H., & Lestari, D. (2019). Application of an automatic pumping system to improve energy efficiency in palm oil mills. Journal of Electrical Engineering, 14(3), 55–68.
Setiawan, B. (2018). Optimization of pumping systems in the palm oil industry by selecting efficient pumps. Journal of Mechanical Engineering, 9(2), 33–47.
Sherina, T. (2019). Study of the implementation of submersible pumps in automatic pumping systems in the palm oil industry. Journal of Agricultural Technology, 11(1), 77–89.
Widodo, A. (2021). Management of carriage transfer ponds to improve pumping efficiency in PKS. Journal of Environment and Engineering, 13(2), 112–126.
License
Copyright (c) 2025 Daniel Joshua Batubara, Deni Rachmat
This work is licensed under a Creative Commons Attribution 4.0 International License.
How to Cite
